LANTest Pro with Tone Tracing Probe

• Introduction
• Features
• Specifications

Introduction

The LANtest Pro is a small hand-held tester that enables the user to quickly read the status of Ethernet twisted pair cables. It tests for faults such as open circuits, shorts, crossed pairs, reversed pairs and split pairs in seconds. The Tone generator function can send a signal through your installed cables and the probe can then trace the cable to locate the fault.

The LANtest Pro includes one master unit and one remote unit easily operated by one person testing patch cords or installed cables. The small remote unit is designed to slip into the master unit to prevent loss or damage top

Features

• Tests for wiring faults of open, short, reversed, crossed and split pairs
• Split pair fault detection at a minimum 40cm cable length
• Verification of shield integrity
• Specially designed remote unit that enables one person to test installedcables
• Easy to read fault display and high speed testing
• Debug mode for detailed fault identification results
• Auto sleep mode and power off switch to decrease power consumption
• Low battery indicatortop

Specifications:

• Connectors
  LANtest Pro Main Unit - RJ45 jack
  Remote Unit - RJ45 jack
• Pairs testes
  1/2, 3/6, 4/5, 7/8 and shield
• LED display
  Horizontal: 5 Green LEDs for pairs and shield display
  (1-2, 3-6, 4-5, 7-8 and SHIELD)
  Vertical: 5 Red LEDs for fault display
  (OPEN, SHORT, REVERSED, CROSSED, SPLIT PAIRS and LOW BATTERY)
• Cables test length limit
  Minimum: 0.4m Maximum: Over 200m
• Power
  6V alkaline DC battery (not included)
• Remote identifier
  no battery required
• Dimensions:
  LANtest Pro - 125 x 52 x 30 mm (L x W x H) top